Upper fuser roller, Fuser film assembly, Fuser film sleeve

A heating component is inserted inside the fuser roller with a yield of around 1.5kW. It is automatically off and on, and this depends upon the requirement of Fuser film assembly. It is constrained by a thermistor that is in touch with the covering on the roller. This makes critical wear and harm.

Likewise, the rolls are exposed to a heap of roughly over the fuser length to make a touch around 5mm wide, which permits time for the melding cycle to happen.

Fuser Roller Materials

There are only two types of fuser materials:

• Silicone elastic
• fluoroelastomers

Both have every one of the important actual properties, and these are normally used to cover an empty metal center to deliver the fuser roller. Certain grades of silicone elastic have both the essential warmth obstruction and required delivery, yet the fluoroelastomers should be utilized related to a grease framework to give agreeable delivery.

Without the right delivery properties, the toner will adhere to the fuser roller, bringing about helpless duplicate quality.

If you want to buy the Upper fuser roller and Fuser film sleeve, contact Foshan Yat Sing! We have the best quality and the most trusted products for you.

Buy the best for your need and get it at reasonable rates only from the Foshan Yat Sing.

By Admin

Leave a Reply

Your email address will not be published.